EasyManua.ls Logo

Nussbaum SPL 4000 - 4 Safety regulations; Key Safety Directives; 5 Operating Instructions; Operational Controls Overview

Nussbaum SPL 4000
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating Instruction and Documentation
SPL 4000
- 18 -
4 Safety regulations
If you use the automotive lift, the German following regulations are to be considered:
BGG945: Examine of automotive-lifts; BGR500 Using automotive-lifts; (VBG14).
Especially the following regulations are very important:
The laden weight of the lifted vehicle must not exceed 4000 kg for the automotive lift.
The automotive lift must be in its lowest position (fully collapsed), before the vehicle can
be driving on to the lift. Only then can the vehicle be lifted.
While working with the lift the operating instructions must be followed.
Vehicles with low clearance or vehicles that are specially equipped should be pre tested
to ensure that they clear the lift ramp to avoid damage.
Only trained personnel over the age of 18 years old are to operate this lift.
No one is to stand within the working area (danger area) during lifting and lowering
No one is to be raised or lowed either directly or in a vehicle by the automotive lift.
No one is to climb onto the automotive lift or onto an already raised vehicle.
The automotive column lift must be checked by an expert after changes in the
construction have been made.
The main switch must be switched off and locked before work on the vehicle can commence. This
is a safety precaution to ensure that the lift does not move during work.
The main switch must be switched off and locked before any maintenance or repair work
on the automotive lift itself can be carried out.
During lifting or lowering the operator must observe the vehicle to ensure that the vehicle
and the lift are functioning correctly.
Installation of the standard-mobile column lift in hazardous or dangerous locations such
as washing bays is dangerous and is not allowed.
Check the centre of gravity of the vehicle if heavy parts (e.g. the motor) are removed.
If heavy parts must be removed (motor) the centre of gravity will change. Secure the
vehicle before removing parts to avoid the possibility of the vehicle becoming insecure.
5 Operating Instructions
The Safety Regulations must be observed and adhered to while working with the
automotive lift. Read the safety regulations in chapter 4 carefully before working with
the lift!
Pic. 1: Operational control
Pic 1:
A button “lifting”
B lever “lowering” + button “unlocking the ratchets”
C main switch

Related product manuals