Nussbaum Sprinter NT - Page 20

Operating Instruction and Documentation
Sprinter NT
- 20 -
abruptly lifting from the lowest position, unequal platform with load, not
complete lowering of a platform in the lowest position.
Right equalisation:
Assumption: One platform is higher than the other platform.
Measure:
• Lower the lift in the lowest position. Press the button “lowering”.
Equalize the lift without load, otherwise the vehicle can mighty fall down.
• Remove on the right side and the left side the covers of the operating unit.
pic. 2
Position X =
The bore hole in the cover is for the equalisation screw.
• Loose the locknuts (SW17) of the equalisation screws A1 and A2 with a suitable
tool.
• Open
slowly
the screw A1 and A2. Press the button “lowering” until both
platforms are on the lowest position.
• During this process both platforms get balanced.
Further measure:
• Close the equalisation screw A1 and A2 and safe it with the locknut.
Close after equalisation the screws A1 and A2 and the locknuts. Otherwise a
malfunction of the lift may occur.
• Raise the lift in the upper end position. Press the button “lifting”
• Open the screws A1 and A2.
• Press the button "lowering". Lower the lift approx. 50 mm