NuWave PIC Gold - Troubleshooting Guide; Error Code Explanations and Solutions

To Next Page

To Previous Page

14 • NuWave

PIC Gold Complete Cookbook

Troubleshooting

Solution

Error

Message

FULL

The unit is malfunctioning. Contact customer service.

An E1 reading typically means that your NuWave PIC Gold does not

detect cookware on its surface. This can occur for one of

two reasons.

1. The induction coils contained within the NuWave PIC Gold will

only work when they are in direct contact with a piece of cookware.

To maintain your appliance’s effectiveness, always ensure that

it rests on a at surface and that contact is consistent with your

cookware.

2. An E1 message may also occur if your chosen cookware is not

induction-ready.

The unit’s voltage is too low. Minimum = 160 volts

The unit’s voltage is too high. Maximum = 270 volts

Overheating, or air ventilation is obstructed. If internal temperature

exceeds 110ºC, operation will cease and a “beep” noise will be

produced. Press “Pause/Clear” twice. Wait for the unit to cool.

In programming mode, when the total entered time reaches the

appliance’s limit of 99:60, no additional stages can be inputted.

Overheating, if unit exceeds a temperature 10ºC higher than sear,

the appliance will turn off. Contact customer service.

The unit is malfunctioning. Contact customer service.

• When any of the above error messages display on the LED, the unit will “beep” at

least once.

• The fan will run up to a maximum of 60 seconds after pressing the “Pause/Clear

button once. Continue cooking by pressing the “Start” button within 45 minutes.

• The unit will turn off after 45 minutes if no buttons (such as “Start”) are pressed.

When the unit shuts off, it will clear all previous cooking history.

• After pressing the “Pause/Clear” button twice or cooking has stopped, the fan will run

up to a maximum of 60 seconds until the unit cools. At that point the NuWave PIC

Gold will turn off.

Other manuals for NuWave PIC Gold