Nvidia DGX H100

NVIDIA DGX H100 User Guide
Before the First Boot Setup
Caution: You perform the First Boot Setup to change the default credentials before connecting
the BMC to an unsecured network.
▶ The default credentials are:
▶ Username: admin
▶ Password: admin
Caution: When you create a BMC admin user, we strongly recommend that you change the default
password for this user - DO NOT use the default password.
After the First Boot Setup
During the rst-boot procedure, you were prompted to congure an administrator username and pass-
word and a password for the BMC. The BMC username is the same as the administrator username:
▶ Username: <administrator-username>
▶ Password: <bmc-password>
1. Make sure you have connected the BMC port on the DGX H100 system to your LAN.
2. Open a browser within your LAN and go to https:∕∕<bmc-ip-address>∕
Make sure popups are allowed for the BMC address.
3. Log in.
4. From the navigation menu, click Remote Control.
The Remote Control page enables you to open a virtual Keyboard/Video/Mouse (KVM) on the
DGX H100 system, as if you were using a physical monitor and keyboard connected to the front
of the system.
5. Click Launch KVM.
The DGX H100 console appears in your browser.
20 Chapter 2. Connecting to the DGX H100