NXP Semiconductors S32K116 EVB User Manual

EXTERNAL USE
APPLIES FOR: S32K116 EVB (SCH_30003 REV B)
QUICK START GUIDE
S32K116 EVB

NXP Semiconductors S32K116 EVB Specifications

General

Microcontroller	S32K116
Architecture	ARM Cortex-M0+
Operating Frequency	48 MHz
Flash Memory	128 KB
RAM	16 KB
Temperature Range	-40°C to 105°C
Debug Interface	SWD
Operating Temperature	-40°C to 105°C
Connectivity	CAN, LIN, UART
On-board Debugger	Yes, integrated OpenSDA debugger
Communication Interfaces	I2C, SPI
ADC Channels	Up to 16 channels (12-bit ADC)

Summary

Jumper Settings Configuration

S32K116 EVB Out of the Box Setup

Power Up the Board: EVB Power Supplies

Using S32K116 with FreeMASTER

Install the FreeMASTER Tool

Download and install the FreeMASTER PC application for development.

Setup Serial Connection in FreeMASTER

Introduction to OpenSDA Debug Adapter

Enter OpenSDA Bootloader Mode

Steps to put the EVB into bootloader mode for software updates.

Load OpenSDA Application

Update or change the installed OpenSDA application, like the MSD Flash Programmer.

MSD Flash Programmer for MCU Programming

Program the MCU by copying .srec files to the EVB's removable drive.

Installing S32 Design Studio (S32DS)

Download S32 Design Studio

Obtain the S32 Design Studio for ARM development environment.

Creating a New Project in S32 Design Studio

Select Workspace for New Project

Select Debugger and Library Support

OpenSDA Debug Configuration

Select OpenSDA for Debugging Setup

Configure the debug settings to use OpenSDA for project debugging.

Configure GDB PEMicro Interface Debugging

Set up the GDB PEMicro Interface Debugging configuration.

Select Target Device for P&E Debugging

Choose the specific target device (S32K116) for the debugging session.

Debugging Fundamentals

Starting the Debugger Session

Learn the recommended method to initiate the debugging process.

Debug Execution Control Actions

Setting and Managing Breakpoints

Creating a P&E Debug Configuration (Optional)

New P&E Debug Configuration Steps

Select Target Device for P&E Debugging