NXP Semiconductors S32K142 User Manual

EXTERNAL USE
REV3
APPLIES FOR: S32K142 EVB (SCH_29701 REV D/C)
QUICK START GUDE
S32K142 EVB

NXP Semiconductors S32K142 Specifications

General

Microcontroller Series	S32K
Core Size	32-Bit
Maximum Frequency	80MHz
Speed	80MHz
Flash Memory	Up to 512 KB
Program Memory Size	Up to 512 KB
Program Memory Type	Flash
Temperature Range	-40°C ~ 105°C
Operating Temperature	-40°C ~ 105°C
Package Type	LQFP
Package / Case	64-LQFP
Number of I/O	Up to 51
Core	ARM Cortex-M4F
Connectivity	CAN, I2C, LIN, SPI, UART
Peripherals	PWM

Summary

S32K142 EVB Component Overview

S32K142 EVB Key Features

S32K142 Header and Pinout Mapping

S32K142 EVB Jumper Settings

S32K142 HMI Component Mapping

S32K142 EVB LIN Phy Errata

Powering Up the S32K142 EVB

Verifying S32K142 EVB Power Status

Introduction to OpenSDA

Enter OpenSDA Bootloader Mode

Steps to enter OpenSDA bootloader mode for the evaluation board.

Load an OpenSDA Application

Instructions to load or update an OpenSDA application on the board.

OpenSDA Application Usage

Using the MSD Flash Programmer

Guide on programming the S32K142 MCU using the MSD Flash Programmer.

Using the Virtual Serial Port

How to establish communication via the virtual serial port.

Download S32DS Software

S32DS Project Creation: Workspace Setup

S32DS Project Creation: IDE Navigation

S32DS Project Creation: Project Details

S32DS Project Creation: Finalize Project

OpenSDA Debug Configuration: Initial Steps

Select Project and Initiate Debug Configuration

Steps to select the project and start the debug configuration process in the IDE.

OpenSDA Debug Configuration: Debugger Settings

OpenSDA Debug Configuration: Interface Selection

Creating Example Project from SDK: Project Selection

Select Project from SDK Example

How to choose an example project from the Software Development Kit within the IDE.

Creating Example Project from SDK: Hello World Example

Creating Example Project from SDK: Build and Debug

Creating Example Project from SDK: Documentation Reference

Debug Basics: Starting the Debugger

Debug Basics: Execution Control

Debug Basics: View and Alter Variables

Debug Basics: View and Alter Registers

Debug Basics: View and Alter Memory

Debug Basics: Breakpoints

Debug Basics: Session Management

P&E Debug Configuration: Create New Launch

Access Debug Configurations

Navigational step to open the debug configurations window in the IDE.

P&E Debug Configuration: Select Debugger Tab

P&E Debug Configuration: Select Target Device

Useful Resources and Links