Need help?Do you have a question about the NXP Semiconductors Layerscape LS1028A BSP and is the answer not in the manual?
General| Cores | 2 |
|---|---|
| Memory | DDR4 |
| Memory Speed | Up to 2400 MT/s |
| Max Memory | 8GB |
| USB Ports | 2x USB 3.0 |
| Operating Temperature | -40°C to 85°C |
| Processor | NXP QorIQ Layerscape LS1028A |
| Architecture | ARM Cortex-A72 |
| Storage Interfaces | SATA 3.0 |
| Ethernet | 2x Gigabit Ethernet ports |
Lists and explains additional documents and resources for the LS1028A SoC.
Details the new features and changes in LS1028A BSP v0.3.
Provides an overview of processor, board, frequency, SerDes, and multimedia support.
Lists the CAF/github locations and commit/tags for BSP components.
Guides through downloading, assembling, and deploying LS1028A BSP images.
Details the steps to download and assemble LS1028A BSP images using Flexbuild.
Explains the procedures for deploying LS1028A BSP images onto a reference board.
Provides detailed steps for building the LS1028A BSP using Flexbuild.
Describes the steps to run secure boot on the LS1028A RDB/QDS board.
Explains the Kbuild sub-system for configuring and building the Linux kernel.
Details various device drivers supported by the LS1028A BSP.
Details the SEC v4.x/v5.x driver and crypto algorithms support.
Covers USB 3.0 host/peripheral driver and modes of operation.
Explains the working of HS Host and HS Device in Linux.
Documents interface naming and Ethernet controllers.
Explains ENETC PF and VF driver modules and configuration.
Describes the L2Switch driver, modules, and configuration.
Details Time Sensitive Network (TSN) configuration and examples.
Provides TSN configuration examples for ENETC.
Provides TSN configuration examples for the switch.
Covers LCD controller, eDP controller, and GPU drivers.
Describes how to configure and test LCD controller and eDP drivers.
Details the NXP Graphics Processing Unit (GPU) driver.
To Next Page