NXP Semiconductors Layerscape LS1028A BSP - Qbu Test

tsntool> qcisgiset --device eth0 --index 2 --initgate 1 --gatelistfile sgi1.txt
#fluding frame size 64bytes at test center
tsntool> qcisfiget --device eth0 --index 2
#check the frames dropped and passed, should be same.
FMI test
Only send green color frames, set test center speed to 10000000 bsp/s:
tsntool> qcisfiset --device eth0 --index 2 --gateid 2 --flowmeterid 2
tsntool> qcifmiset --device eth0 --index 2 --cm --cf --cbs 1500 --cir 50000 --ebs 1500 --eir 5000000
Below setting shows drop frames.
tsntool> qcifmiset --device eth0 --index 2 --cm --cf --cbs 1500 --cir 50000 --ebs 1500 --eir 2000000
The following example shows how to get information of color frame counters showing at application layer.
tsntool> qcifmiget --device eth0 --index 2
=======================================================================
bytecount drop dr0_green dr1_green dr2_yellow remark_yellow dr3_red remark_red
1c89 0 4c 0 0 0 0 0
=======================================================================
index = 2
cir = c34c
cbs = 5dc
eir = 4c4b3c
ebs = 5dc
couple flag
color mode
4.2.13.3.4
Qbu test
Set frame path from eth0 to external by link enetc MAC0 - SWP0.
Figure 11. QBU test setup
• 0x11f10 Port MAC Merge Frame Assembly OK Count Register
• 0x11f18 Port MAC Merge Fragment Count TX Register (MAC_MERGE_MMFCTXR)
NOTE
Linux kernel
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
116
NXP Semiconductors