NXP Semiconductors Layerscape LS1028A BSP - Page 115

6. Send one frame from Test center.
tsntool>qcisfiget --device eth0 --index 2
#should look result like below:
match pass gate_drop sdu_pass sdu_drop red
1 0 1 1 0 0
Test Null Stream identify Entry
Follow the following procedure to set main stream by close gate.
1. Set Stream identify Null stream identify entry 1.
tsntool> cbstreamidset --device eth0 --index 1 --nullstreamid --nulldmac 0x000000800010
--nulltagged 3 --nullvid 10 --streamhandle 100
2. Get SID index 1.
tsntool> cbstreamidget --device eth0 --index 1
3. Set Stream filer entry 1.
tsntool> qcisfiset --device eth0 --streamhandle 100 --index 1 --gateid 1
4. Set Stream Gate entry 1.
tsntool> qcisgiset --device eth0 --index 1 --initgate 0
5. Send one frame from Test center.
tsntool> qcisfiget --device eth0 --index 1
#should look like below:
match pass gate_drop sdu_pass sdu_drop red
1 0 1 1 0 0
Test Source Stream identify Entry
1. Keep Stream Filter entry 1 and Stream gate entry 1.
2. Add stream2 in test center: SMAC is 66:55:44:33:22:11 DMAC:20:00:80:00:00:00
3. Set Stream identify Source stream identify entry 3.
tsntool> cbstreamidset --device eth0 --index 3 --sourcemacvid --sourcemac 0x112233445566 --
sourcetagged 3 --sourcevid 20 --streamhandle 100
4. Send frame from test center. The frame passes to stream filter index 1.
tsntool> qcisfiget --device eth0 --index 1
SGI stream gate list
cat > sgi1.txt << EOF
t0 0b -1 1000 0
t1 1b -1 1000 0
EOF
tsntool> qcisfiset --device eth0 --index 2 --gateid 2
Device Drivers
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
NXP Semiconductors
115