NXP Semiconductors S32K144 EVB - Jumper Settings

EXTERNAL USE
5
Jumper Settings
Jumper Configuration Description
J104 1-2
2-3 (Default)
Reset signal to OpenSDA, use to enter into
OpenSDA Bootloader mode
Reset signal direct to the MCU, use to reset
S32K144.
J107 1-2
2-3 (Default)
S32K144 powered by 12V power
source.
S32K144 powered by USB micro
connector.
J109/J108 1-2 (Default) Removes CAN termination resistor