30 31
I/M Readiness
Reading PID.01
- Please Wait -
I/M Readiness
Since DTCs Cleared
This Drive Cycle
Diagnostic Menu
1) Read Codes
2) Erase Codes
3) Datastream
4)
5) I/M Readiness
6) O2 Monitor Test
View Freeze Frame
2) Wait a few seconds while the Scan Tool validates the PID MAP.
3) If the vehicle supports both types of tests, then both types will be
shown on the screen for selection.
Since DTCs Cleared
MIL Status
Misfire Monitor
Fuel System Mon
Comp. Component
Catalyst Mon
Htd Catalyst
OFF
OK
OK
OK
INC
N/A
This Drive Cycle
MIL Status
Misfire Monitor
Fuel System Mon
Comp. Component
Catalyst Mon
Htd Catalyst
OFF
OK
OK
OK
INC
N/A
4) Use the scroll buttons, as necessary, to view the
status of the MIL light ( ) and the following
monitors:
UP/DOWN
ON or OFF
-- Misfire monitor
-- Fuel System Monitor
-- Comprehensive Components Monitor
-- EGR System Monitor
-- O2 Sensors Monitor
-- Catalyst Monitor
-- Evaporative System Monitor
-- O2 Semspr Heater Monitor
-- Secondary Air Monitor
-- Heated Catalyst Monitor
-- A/C system Monitor
Misfire monitor
Fuel System Mon
Comp. Component
EGR
Oxygen Sens Mon
Catalyst Mon
EVAP System Mon
Oxygen Sens htr
SecAir System
Htd Catalyst
A/C Refrig Mon
5) If the vehicle suppotrs readiness test of , a
screen of the following will be displayed:
This Drive Cycle
To Next Page
Loading...