38 39
Component Test
The selected mode is
Not supported
Pressanykeytocon.
Diagnostic Menu
07) On-Board Mon. Test
08) Component Test
09) Vehicle Infor.
10) Modules Present
11) Unit of Measure
Vehicle Info.
Calibration ID
Cal. Verif. Number
Vehicle Info.
Reading PID.01
- Please Wait -
Calibration ID
Cal Id1 :
30668343
Cal Id2 :
08644359
3) From the Menu, use the scroll buttons
to select the available items to view and press the button.
Vehicle Info. UP/DOWN
Y
4) View the vehicle information retrieved.
4.9 Viewing Vehicle Information
The Vehicle Information function enables the retrieval of the
Vehicle Identification No.(VIN), Calibration ID(s), Calibration
Verification Nos.(CVNs) and In-use Performance Tracking on
2000 and newer vehicles that support Mode 9.
1) Use the scroll buttons to select Ftom the
and press the button.
UP/DOWN Vehicle Info.
Diagnostic Menu Y
2) Wait a few seconds while the Scan Tool validates the PID MAP.
Some vehi c les do not allow scan toolstocontr ol vehicl e systems
or components. If the vehicle under test does not support the
EVAP Leak Test, an advi sory message is displayed on the screen.
If the vehicle does not support this mode, a message will show on
the displaywarningthat the mode is not supported.
To Next Page
Loading...