22 23
Stored Codes
Manufacturer Specific
Codes found! Press any
keytonextscreen
to selsct manufacturer.
Vehicle Manufacturer
1) Alfa Romeo
2) Audi/VW
3) BMW
4) Buick
5) Cadillac
6) Chevrolet
Diagonstic Menu
1) Read Codes
2) Erase Codes
3) Datastream
4) View Freeze Frame
5) I/M Readiness
6) O2 Monitor Test
Erase Codes
Erase trouble codes!
Are you sure?
YES <NO>
11) If more than one DTC is found, use the scroll buttons,
as necessary, until all the codes have been shown up.
UP/DOWN
The control module number, sequence of the DTCs, total number
of codes detected and type of codes (Generic or Manufacturer
specific, Stored or Pending codes) will be observed on the upper
right hand corner of the display.
When a DTC
,
s definition covers more than one screen, use the
button, as necessary, to view any additional information.
Y
If the retrieved DTCs contain any manufacturer specific or
enhanced codes, you will be prompted to select the vehicle
manufacturer to view DTC definitions. Use the scroll
buttons to select the manufacturer and then press the button to
confirm.
UP/DOWN
Y
If the manufacturer for your vehicle is not listed, use the
scroll buttons to select and press the button.UP/DOWN Other Y
4.2 Erasing Codes
CAUTION: ErasingtheDiagnostic Trouble Codes may allow the
scan tool to delete not only the codes from the vehicle
,
son-board
computer, but also Freeze Frame dataandmanufacturer specific
enhanced data.Further, the I /M Readiness Monitor Status for all
vehiclemonitors is reset to Not Ready or Not Complete status. Do not
erase the codes before the system hasbee
n checked completelybya
technician.
1) If you decide to erase the DTCs, use the scroll
buttons to select from the and
press the button.
UP/DOWN
Erase Codes Diagnostics Menu
Y
This function is performed with key on engine off (KOEO). Do not
start the engine.
2) A warning message comes up asking for your confirmation.
To Next Page
Loading...