14
616 01 1017 02
4. Press START; then use the ▲ or ▼ to change the time the
corresponding period starts.
5. Press HEAT TO; then use the ▲ or ▼ to change the desired
heating temperature for that period.
6. Press COOL TO; then use the ▲ or ▼ to change the desired
heating temperature for that period.
7. Press DONE after you have completed your edits.
8. Press SAVE to save your new schedule and exit (or press
CANCEL to exit without saving.)
Installation
Overview
This instruction covers installation of the Observer Control
only. Physical installation instructions for the indoor and out
door equipment and accessories are provided with each unit.
Setup, commissioning, operation, and troubleshooting of the
communicating system are covered only in this installation
instruction. It is the guide to connecting the system compon
ents and commissioning the system once all physical com
ponents are installed. Special screen prompts and startup
capabilities are provided in the communicating system to
To Next Page
Loading...
