15
616 01 1017 02
simplify and automate the initial commissioning of the sys
tem.
Install Observer Control according to this instruction.
Install indoor unit, outdoor unit, and accessories according
to their instructions.
Wire complete system according to this instruction.
Setup, commission, and operate system according to this
instruction to assure a smooth and trouble free startup.
Check Equipment
Inspect equipment. File claim with shipping company prior to
installation if shipment is damaged or incomplete.
Location
All wiring must comply with national, local, and state codes.
Wall Control
The Observer Control is the command center for the commu
nicating system. It should be located where it is easily ac
cessible and visible to the adult homeowner or end user. For
accurate temperature measurement, the following guidelines
should be followed:
The Observer Control and Room Sensors SHOULD be
mounted:
Approximately 5ft (1.5 m) from the floor.
To Next Page
Loading...
