Observer TSTAT0101SC - One Schedule for All Days

To Next Page

To Previous Page

616 01 1017 02

Mounting

First become familiar with all plastic assembly pieces shown

in Figure 2. The wall control will snap together with the

backplate. A backplate is supplied Figure 2. Attach

backplate using only a small hole in the wall allowing a four

wire connection to pass through. Mount the assembly to the

backplate.

NOTE: Once Observer Control is secured to wall with the

backplate assembly (snapped together), care must be taken

not to bend or break the interlocking tabs when removing.

Other manuals for Observer TSTAT0101SC