Observer TSTAT0101SC - Programming; Smart Recovery; English;Metric Display; Airflow

58
616 01 1017 02
Programming
ON (default)  allows program schedule to be set by user.
OFF  system becomes nonprogrammable
Smart Recovery
This feature applies to programmable operation only. The
control will start recovery 90 minutes prior to schedule
change in both heating and cooling mode. Refer to opera
tional information for more detail.
On or Off (default = On)
English/Metric Display
ºF or ºC, (default = ºF)
Airflow
Upon a first time startup of the Observer Control, the fur
nace DIP switch settings will be copied to the furnace setup
menu. Any changes can then be made from the Observer
Control.