25
616 01 1017 02
Once the indoor and outdoor equipment has been found, the
Installer will be asked to select if a humidifier is installed.
NOTE: If the communicating indoor equipment (furnace or
fan coil) cannot be found, the wall control will display the op
tion to enter THERMOSTAT DEMO MODE or to retry the
search for equipment. The system will only operate in THER
MOSTAT DEMO MODE if no communicating equipment is
found.
If a communicating indoor unit is found, but a communicating
outdoor unit or relay board is not found, the installer will be
prompted to select the outdoor type; either AC, Heat Pump,
or NONE.
To Next Page
Loading...
