CS9350 User’s Guide
4-71
4.1.2 Cautions on handling media
Note the following points when handling the media.
Use recommended media under an appropriate environment.
The appropriate temperature and humidity for printing are as follows.
Do not use media which is folded, cut, or torn.
The size of media can change according to changes in humidity in the printing
environment. Before using media, leave media for 30 minutes in the printing environment
to adapt it to the environment.
Performing printing without adapting media to the printing environment may cause media
jams due to gaps or wrinkles in the media. Print quality is also affected.
When using the printer in a low-humidity environment, the cut media may stuck and may
not come down. In such a case, open the front cover after the media is cut to remove the
media.
Do not touch the print side. Moisture and oil on your hands may affect the print quality.
Do not leave media set in the printer for a long time.
Some media has a tendency to bend, causing media jams and degradation of print quality.
Avoid using such media especially in winter, in dry conditions, and when printing formal
documents.
Do not discard the individual box and bag. Use them for storing media.
4.1.3 Precaution on storing media
Note the following points on storing media.
Avoid high temperature, high humidity, and direct sunlight when storing media.
After removing the unused roll media from the scroller, wind it properly. Then wrap it with
an individual bag and store it in an individual box.
Keep the media dry.
Temperature Humidity
Guaranteed range of printing accuracy
40% to 60%
Within 5 % per hourChange rate
22 C to 30 C
Within 2 C per hour
To Next Page
