CS9350 User’s Guide
4-86
4.3.4 Cutting media manually
Right after printing, the media guide becomes very hot.
Allow the media guide to cool down before the next operation.
Step 1: Verify the following regarding the operational condition of the product.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
Step 2: To change the position to cut the roll media, refer to “4.4.1 Feeding media” and advance the
roll media to the desired cut position.
Step 3: Place a razor blade on the media cut groove on the media guide, and cut the roll media.
Pay attention to the following points when cutting roll media.
Mishandling the razor blade may cause a cut on your finger or hand.
When you hold media, do not place your finger on the media cut groove.
Move the razor blade along the media cut groove.
• The procedure for cutting the roll media is complete.
When loading the new roll media, cut the front edge of the media if it is not straight.
N° Name
1 Media guide
2 Media cut groove
3 Razor blade
To Next Page
