Why is my Oce im3512 asking for a password?
If your Oce All in One Printer is requesting a password, it's likely because a password was set for the retention function. A password is required to proceed with printing. If you don't know the password, printing cannot be executed.
How to resolve Oce All in One Printer write error when printing from USB?
If your Oce All in One Printer is experiencing a write error when printing from the USB port, the timeout setting for the printer driver might be too short. Try setting a longer timeout duration in the printer driver settings.
How to correct the orientation of the image on my Oce All in One Printer?
If the orientation of the image is incorrect on the print from your Oce All in One Printer, the print orientation settings in the printer driver may be incorrect. Correct the orientation settings directly in the printer driver.
Why is the printed image cut off by my Oce All in One Printer?
If the printed image from your Oce All in One Printer is cut off, it is possible that an incorrect ratio has been selected. To resolve this, select a suitable ratio when printing.
How to fix Oce All in One Printer that prints in reverse order?
If your Oce All in One Printer prints in reverse order, the reverse page order setting might be enabled in your software application. Disable this setting in the application software to print in the correct order.
What to do if my Oce All in One Printer receives data but does not print?
If your Oce All in One Printer receives data but doesn't print, it might be due to the loaded paper not matching the specified size and type. Load the correct paper, select a different paper size, or cancel the printing job.
Why can't I select my Oce im3512 All in One Printer from my computer?
If your Oce All in One Printer isn't being selected by your computer, ensure that the appropriate printer driver has been installed correctly. If not, install the driver.
What to do if my Oce im3512 All in One Printer stops in the middle of a print job?
If your Oce All in One Printer stops mid-print, it might be due to the exit tray being full. Remove the paper from the exit tray and try again. Also, check if the printer is out of paper and load paper if necessary.
Why is my Oce im3512 All in One Printer on but not receiving data?
If your Oce All in One Printer is on but not receiving data, first ensure the USB cable is correctly connected to both the printer and your computer. If the connection is correct, verify that you've installed the appropriate printer driver. Finally, confirm that the correct printer driver is selected in your software application or that the printer is correctly registered on the network. If not, consult your network administrator.
General| Print Technology | Laser |
|---|---|
| Scanning Resolution | 600 x 600 dpi |
| Copy Resolution | 600 x 600 dpi |
| Duplex Printing | Yes |
| Fax Transmission Speed | 33.6 Kbps |
| Functions | Print, Copy, Scan |
| Print Speed (Black) | 35 ppm |
| Connectivity | USB, Ethernet, Wi-Fi |
| Scanner Type | Flatbed, ADF |
| Copy Speed | 35 cpm |
| Operating System Compatibility | Windows, macOS |
| Power Consumption | 1, 200 W (max) |
To Next Page
