Installation and Customization
U20944-J-Z247-6-7600
DDDEF ZONE DATA SET INITIAL FINAL WAITFORDSN
ASPSDLIB DLIB SPS.ASPSDLIB OLD KEEP YES
ASPSSAMP DLIB SPS.ASPSSAMP OLD KEEP YES
ASPSMESS DLIB SPS.ASPSMESS OLD KEEP YES
SPSLINK TARGET SPS.SPSLINK SHR KEEP YES
SPSSAMP TARGET SPS.SPSSAMP SHR KEEP YES
SPSMESS TARGET SPS.SPSMESS SHR KEEP YES
Table 5: SPS DDDEF Allocations
Adjust JCLIN for LPALIB Installation (OPTIONAL)
This step is only necessary if you want to install the re-entrant parts of SPS in the
LPA/ELPA instead of in SPS.SPSLINK. To determine whether it is useful to install SPS in
the installation LPA/ELPA, please read "Virtual and Real Storage Considerations" on page
71 and "Memory" on page Error! Bookmark not defined.. This function can also be
performed with UCLIN if the installation prefers.
Duplicate the JCLIN for the link-edits of base product modules SPSMFSS, SPSMLI (alias
SPSMFSSM), SPSMDOPN, IGG019WM and IGG019WS (these 2 last modules may have
another, user specified name. Please see section 0 on page 55). Duplicate the JCLIN as
needed for link-edits of LINE modules SPSPLINE, SPSPLIP and SPSPEPM, or APA
module SPSPAPA2. The modules SPSMPDEF, SPSMGDA and all the header, separator,
message, and trailer page load modules cannot be moved to LPALIB as they are actually
non-reentrant data areas. The direct printing modules SPSMDCAU, SPSMDLCN,
SPSMDLOP and SPSMDSSI should not be installed in LPALIB. They will only waste LPA
space when installed in LPALIB.
The JCLIN may be found in the respective SPS.fmid.F1 library and may be altered using
the ISPF editor. Change the copies from the distribution coded library name
SPS.SPSLINK to SYS1.LPALIB. Any library that is used in the building of LPA during
initialization may be selected instead of SYS1.LPALIB. The list of libraries in the
installation that are used to build LPA can be found in LPALST00 of SYS1.PARMLIB.
Additionally an installation may use libraries in LPALSTxx members that are selected by
the LPA parameter in IEASYS00.
The duplication of the link-edits is recommended so that the entire SPS product is in one
library that can be used as a steplib. This is useful for testing and after maintenance is
applied. When LPALIB is used for the re-entrant SPS modules and the modules are also
in SPSLINK, SPSLINK must be in linklst. If SPSLINK is used as a steplib, the LPA copies
will be ignored.
To Next Page
Loading...
