Maintenance
U20944-J-Z247-6-7600
7 OPERATION
In addition to the JES printer related commands supported by SPS (like $PPRTx,$SPRTx,
$CPRTx, etc...) there are also some commands given directly to SPS (not via JES) to
achieve some other functions.
OS/390 (MVS)
MVS Commands
STOP (P) Command
This MVS command allows the operator to terminate one SPS procedure when no
printers are started.
The format of this command is:
P procid
where:
procid is the procedure id used to start the SPS procedure and corresponds to
the FSS id specified in the JES2PARM.
When any printer is started for the specified procedure and the STOP command is issued
SPS rejects the command with a message indicating that printer(s) are still active.
Another STOP command has to be given later, after all FSS related printers are drained.
JES Commands
The following JES commands are supported by SPS & PP/ROUTER:
$S Start device command
The format of this command is:
$P Stop device command
The format of this command is:
To Next Page
Loading...