Oce PRISMAproduction - Msgsuxxx Member Parameters; Create the PP;ROUTER Router Control Table

Installation and Customization
U20944-J-Z247-6-7600
PPRTRPPX(print parm exit name PPRTRPPX)
TRACELEV( 0
-4 )
TRACETYPE( ALL
| INITERM | REQFLOW | PS |
DISPAT | INVRET | PDS | ORDER | SOCKET )
TRACEFILE( GTF | USER
)
TRACESET( FF,FF,FF,FF,FF,FF,FF,FF
)
DUMP( YES
| NO )
CHARS( font name ) (JCL)
FORMDEF( formdef name ) (JCL)
PAGEDEF( pagedef name) (JCL)
(Optional)
MSGSUxxx member parameters
The MSGSUxxx parameter member which is installed into the SAMPLIB must be used for
all the PP/ROUTER printers in the installation.
The member can be expanded with additional supression entries, or merged together with
an existing supression file at your installation.
Create the PP/ROUTER Router control table
When a dataset has been selected from the spool system for distribution the router control
table is referenced. A matching group entry is sought, the basis being a valid combination
of DEST, CLASS and FORMS entries from the datasets output characteristics. Having
found a matching group entry the IPADDR and PORTNUM are used as the target
destination. Multiple group statements can exist for a single server destination using
different selection criteria. (see PP/ROUTER Administration Guide).
In VSE a routing control file is specified per device, in the SETUP member.
The router table is read by each device as it is started. Therefore to introduce changes in
a routing table, the changes must be made to the table and any device that is to use the
table can then be started, or if already active the device must be stopped and then started
again.