Maintenance
U20944-J-Z247-6-7600
Level 0 corresponds to the minimum trace and level 4 to the maximum of trace
information.
The format of this command is:
F procid,PRTx,TLEV n for CMDIF(MODIFY)
or
R xx,TLEV n for CMDIF(WTOR)
where:
n is a digit between 0 and 4 specifying the new trace level.
TSET Command
This command requests that SPS change the trace set specification (see TRACESET
keyword from SETUPxxx). The traceset controls which components from the PS (print
server) FMID of SPS are traced. The traceset specifications should be changed only on
request from an Océ representative.
The format of this command is:
F procid,PRTx,TSET xxxxxxxxxxxxxxxx
or
R xx,TSET xxxxxxxxxxxxxxxx
where:
xxxxxxxxxxxxxxxx is a 16 character hex string specifying the new traceset value.
Each digit may be 0 - 9 or A - F (one hex digit representation). All 16 digits must be
specified each time this command is 6
VSE
VSE Commands
SPS supports the necessary additional VSE/POWER operator commands for controlling
the printer/s. These are:
S DEV,devname,SPS,class(es)[,PARM='logdest, ...']
devname Specifies the device name. This parameter must correspond to the name
specified for the printer in the PRT keyword of the SPSPRINT system parameter member.
To Next Page
Loading...
