Oce TDS450 - Set the Media Type and Width

Set the media type and width
Set the media type and width
Set the media width
1. Press the On-line key to put the printer off-line.
2. Select the ‘Media settings’ item with the
◄ or ► key.
3. Press Next/select to enter the ‘Media settings’ menu.
4. Select ‘Roll 1’or ‘Roll 2’ with the
◄ or ► key.
5. Press Next/select to enter the ‘Roll’ or ‘Manual feed’ menu.
6. Select the ‘Width’ item with the
◄ or ► key.
7. Press Next/select to enter the ‘Width’ menu.
8. Select the desired width with the
◄or ► key.
9. Press Next/select to confirm the selected width.
10. Press On-line to put the printer on-line again.
Set the media type
1. Press the On-line key to put the printer off-line.
2. Select the ‘Media settings’ item with the
◄ or ► key.
3. Press Next/select to enter the ‘Media settings’ menu.
4. Select ‘Roll 1’, ‘Roll 2’, ‘Manual feed’ with the
◄ or ► key.
5. Press Next/select to enter the ‘Roll’ or ‘Manual feed’ menu.
6. Select the ‘Material’ item with the
◄ or ► key.
7. Press Next/select to enter the ‘Material’ menu.
8. Select the desired media material with the ◄ or ► key.
9. Press Next/select to confirm the selected media material.
10. Press On-line to put the printer on-line again.
19