119
NOTE: When a switch is made to another GAS/
TMT, there may be a delay of 5 to 15 seconds
before the Receiver picks up the TMT's signal.
SWITCHING FROM GAS 1 TO GAS 2
• Depressing the M button for 2 seconds while viewing the
GAS 2 Switch Preview Display will manually Switch the
ATOM from GAS 1 to GAS 2 and the Receiver from Transmit-
ter 1 to Transmitter 2 (if active).
• When the switch is made, the Main Display will represent
GAS 2. Alternate Display #1 will then display the alpha
graphic TMT2 and the Pressure of Tank 2 (Fig. 110). Air
Time Remaining is then calculated based on Tank 2.
SWITCHING FROM GAS 2 BACK TO GAS 1
A Switch Back to GAS 1 can be performed, as follows:
• Press/release the M button momentarily (< 2 seconds) to step
through the Switch Preview screens.
• Depressing the M button for 2 seconds while the GAS 1
Switch Preview screen is displayed will switch the ATOM
from GAS 2 back to GAS 1 and the Receiver from Transmitter
2 back to Transmitter 1.
• When the switch is made, the Main Display will then repre-
sent GAS 1. Alternate Display #1 will then display the alpha
graphic TMT1 and the Pressure of Tank 1 (Fig. 111). Air
Time Remaining is then calculated based on Tank 1.
Fig. 110 - Switch from GAS 1
to GAS 2 was made
Fig. 111 - Switch from GAS 2
Back to GAS 1 was made
To Next Page
Loading...
