51
SET FO2 50% DEFAULT information includes (Fig. 48):
> Graphics DFLT and 50
> Set Point graphic ON (or OFF), flashing.
> Symbols FO2 and NITROX.
• Pressing and releasing the S button (< 2 seconds) will toggle
between ON and OFF.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to SET RECEIVER
with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds) will step through the other SET D screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET D screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 48 - Set FO2 Default
Refer to page 46 for
a description of FO2
50% DEFAULT.
To Next Page
Loading...
