52
SET ATOM's RECEIVER information includes (Fig. 49):
> Graphic RCVR
> Set Point graphic ON (or OFF), flashing.
• Pressing and releasing the S button (< 2 seconds) will toggle
between ON and OFF.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to SET DIGITAL
GAUGE with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds) will step through the other SET D screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET D screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
NOTE: When set OFF, the Receiver is disabled
and does not activate to search for Pressure
signals or Transmitter Battery Status. Displays
and calculations relating to Tank Pressure will
not be made until the Receiver is set ON.
Fig. 49 - Set Receiver
To Next Page
Loading...
