Oceanic ATOM - Page 53

53
SET DIGITAL GAUGE DIVE information includes (Fig. 50):
> Graphic GAUG
> Set Point graphic ON (or OFF), flashing.
• Pressing and releasing the S button (< 2 seconds) will toggle
between ON and OFF.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to the SET D
screen.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds each time) will step through the other SET D
screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET D screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
NOTE: When DIGITAL GAUGE Mode is set ON,
the setting will default to OFF if a dive is not
started within 2 hours or if the Local Default
Time display is selected.
Fig. 50 - Set Digital Gauge