56
SET DEPTH ALARM information includes (Fig. 53):
> Graphic DPTH
> Symbols MAX and FT (or M)
> Set Point graphic value, flashing.
• Pressing and releasing the S button momentarily (< 2 sec-
onds) will step through the Set Points from 30 to 330 feet (9
to 99 meters) in 10 foot (3 meter) increments at a rate of 1
Set Point per press of the button.
• Depressing and holding the S button will scroll through the
Set Points at a rate of 4 Set Points per second until it is
released.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to the SET
ELAPSED DIVE TIME ALARM screen with the Set Point flash-
ing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds each time) will step through the other SET A
screens.
• Pressing the A and S buttons simultaneously for 2 seconds will
save the setting and revert back to the SET A screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 53 - Set Depth Alarm
To Next Page
Loading...
