57
SET ELAPSED DIVE TIME (EDT) ALARM
Information includes (Fig. 54):
> Graphic EDT
> Symbols DIVE and TIME.
> Set Point value, flashing.
• Pressing and releasing the S button momentarily (< 2 seconds)
will increase the Set Point from 0:10 to 3:00 (hours:minutes) in
5 minute (:05) increments.
• Depressing and holding the S button will scroll through the Set
Points at a rate of 4 Set Points per second until it is released.
• Pressing and releasing the A button momentarily (< 2 seconds)
will save the setting and/or advance to the SET TISSUE
LOADING BAR GRAPH (TLBG) ALARM screen with the Set
Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds) will step through the other SET A screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET A screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 54 - Set EDT Alarm
To Next Page
Loading...
