67
SET CONSERVATIVE FACTOR information includes (Fig. 64):
> Graphic CONS
> Set Point ON (or OFF), flashing.
> Symbols TIME and NDC.
• Pressing and releasing the S button (< 2 seconds) will toggle
between ON and OFF.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to the SET BACK-
LIGHT DURATION screen with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds each time) will step through the other SET U
screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET U screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
NOTE: When the Conservative Factor is set ON,
the No Decompression Limit times are reduced to
values equivalent to those that would be avail-
able at the next higher 3000 foot (915 meter)
Altitude. Refer to the tables on Pages 139/140.
Fig. 64 - Set Conservative
Factor
Use the Conservative
Factor option to help
reduce your expo-
sure to Decompres-
sion Sickness.
To Next Page
Loading...
