68
SET BACKLIGHT DURATION information includes (Fig. 65):
> Graphic GLOW
> Symbol TIME.
> Set Point, flashing.
• Pressing and releasing the S button momentarily (< 2 sec-
onds each time) will step through the Set Points of 0, 5, and
10 (:XX seconds).
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to the SET SAM-
PLING RATE screen with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds each time) will step through the SET U
screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET U screen.
• Depressing and holding the M button for 2 seconds will
revert to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 65 - Set Backlight
Duration
The Backlight will
not remain On for
the additional
Duration time set if
the L button is held
depressed longer
than10 seconds.
To Next Page
Loading...
