69
SET SAMPLING RATE information includes (Fig. 66):
> Graphic SAMP
> Symbol TIME (or FT/M).
> Set Point, flashing.
• Pressing and releasing the S button momentarily (< 2 sec-
onds) will step through the Set Points of 2, 15, 30, 60 (:XX
seconds), and 2 FT, 5 FT, 10 FT (or .5 M, 1.5 M, 3 M).
• Depressing and holding the S button will scroll through the
Set Points at a rate of 4 Set Points per second until it is
released.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to the SET TRANS-
MITTER 1 LINK CODE screen with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds each time) will step through the other SET U
screens.
• Depressing the A and S buttons simultaneously for 2 seconds
shall save the setting and revert back to the SET U screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 66 - Set Sampling Rate
SAMPLING RATE is
the frequency (time
or depth change) at
which data is
sampled and stored
in memory for
subsequent down-
load to the PC
OceanLog program.
To Next Page
Loading...
