Oceanic ATOM - Page 70

70
SET TRANSMITTER 1 LINK CODE information includes (Fig. 67):
> Graphics TID1, and ON (or OFF) flashing.
> Set Point (numerical Link Code/transmitter's serial number).
• Pressing and releasing the S button momentarily (< 2 seconds) will toggle between ON
and OFF.
• Pressing and releasing the A button momentarily (< 2 seconds) will accept the ON/OFF
selection.
• If OFF is selected, SET TID2 and TID3 will be bypassed and the operation reverts to the
SET U screen.
• If ON is selected, the first (left) digit of the LINK CODE will flash.
• Pressing and releasing the S button momentarily and repeatedly (< 2 seconds each
time) will increase the First Digit from 0 to 9 in increments of 1.
• Depressing and holding the S button will scroll through the Set
Points at a rate of 4 per second.
• Pressing and releasing the A button (< 2 seconds) will accept
the First Digit of the Code and/or advance to the Second Digit
which will be flashing.
• Pressing and releasing the S button shall increase the Second
Digit from 0 to 9 in increments of 1.
• Depressing and holding the S button will scroll through the Set
Points at a rate of 4 per second.
• Pressing and releasing the A button (< 2 seconds) will accept
the Second Digit of the Code and/or advance to the Third Digit
which will be flashing.
Fig. 67 - Set TID1