45
DataLink (Fig. 32) high-pressure quick disconnect between your computer
and first stage. This allows you to remove the DataMax Pro and keep it
nearby when recording dives in your log book or planning the next dive.
DURING THE DIVE
Keep the DataMax Pro protected from abuse underwater by using the
console retainers on your B.C. If you let it hang freely, expect scratches to
cover the display face after only a few dives. You also may damage delicate
corals or marine life while jarring sensitive electronic components.
AFTER THE DIVE
Soak the DataMax Pro in fresh water after each dive. If possible, use
lukewarm water to dissolve any salt crystals. Salt deposits can also be
dissolved using a slightly acidic vinegar/water bath. After removal from a
fresh water bath, place the DataMax Pro under gently running water. Be
sure to flush any holes or slots on the rear of the boot. Towel dry the com-
puter before storing. Transport the DataMax Pro cool, dry, and protected.
WARNING: Never, under any circumstances, poke any object
through any slots or holes on the rear of the DataMax Pro.
Doing so may damage the depth sensor possibly resulting in
erroneous depth and/or dive time remaining displays.
Fig. 32 – DataLink high
pressure quick disconnect
To Next Page
Loading...
