52
is not covered under warranty. For any other cause of flooding, return the DataMax Pro to your
Authorized Oceanic Dealer for factory service.
REGULATOR INSTALLATION INSTRUCTIONS
The DataMax Pro is an air integrated dive computer that requires
attachment to your regulator system. If possible, have this done by your
Authorized Oceanic Dealer. If this isn’t possible, follow these directions:
CAUTION: Installing the DataMax Pro improperly to your
regulator may damage the dive computer, regulator, or both.
Oceanic strongly recommends that installation should be done
by an Authorized Oceanic Dealer.
Remove your current console, or port plug, from the regulator port
marked “HP” with the proper wrench or hex key. Put a small dab of silicone
grease on the o-ring and threads of the DataMax Pro hose end. Thread and
hand tighten the DataMax Pro hose into regulator body until it stops.
Tighten just over hand tight with a 5/8” open-end wrench. Attach regulator
to a full scuba tank to test connection. Open valve slowly while holding the
DataMax Pro away from your face. After the initial “whooosh” of air enter-
ing the hose, listen for the sound of escaping air at either end of the DataMax
Pro hose. If possible, immerse the tank, regulator, and DataMax Pro under-
water and look for bubbles. If you do not hear, or see, any air escaping the
system is ready for use. If any air leak is seen or heard, take the system to an
Oceanic Authorized Dealer for repair.
To Next Page
Loading...
