Doc. 12-7959-r01 (8/19/20)
7
© Pelagic (2020)
!
CAUTION
To prevent damage resulting from static discharge, the
individual and work station must be grounded when
handling any electronic components.
NOTE
Protect the lens and nish of the ProPlus X by working on
a clean padded surface.
!
CAUTION
Do not use chemicals or alcohol to clean the plastic parts.
1. Install the battery, as shown, by pressing and fully seating
the connector (Fig. 1, 2).
NOTE
The writing on the battery should be facing outwards.
2. Lightly lubricate the battery O-ring with silicone and install it
along the O-ring groove (Fig. 3).
CAUTION
Ensure the O-ring is free of any debris and evenly seated.
3. Ensure that the battery cover still has insulating pads in place
and in good condition (Fig. 4).
REASSEMBLY
Fig. 1
Fig. 2
Fig. 3
Fig. 4
To Next Page
Loading...
