8 Daily operation
Instruction Manual Easyfield® (GA/15000/XXXX/EN 1219 Rev01) 19 / 60
7.4 Setup tasks for Initial Start-Up
When you connect the Easyfield® with a PC for the first time, you will
have to perform several set up steps.
To avoid communications problems, deactivate the power saver mode of
the USB units of the operating system.
Proceed as described in the
Software Installation
.
8 Daily operation
8.1 Switching on Easyfield®
Switch on the netbook, the PC or the laptop.
Wait until the operating system has started completely and the Patient
Data Management screen appears.
Switch on the Easyfield® at the On/Off switch.
8.2 Switching off Easyfield®
Close the Easyfield® program and the Patient Data Management.
Shut down the Windows operating system.
Switch off the Easyfield® at the On/Off switch.
After the exam, cover the unit with the provided dust hood.
To Next Page
Loading...