7 Preliminary steps
16 / 60 Instruction Manual Easyfield® (GA/15000/XXXX/EN 1219 Rev01)
7Preliminary steps
Before the initial operation of the Easyfield® you must first -
Install the software sec. 7.1, page 16
Set up the Easyfield® sec. 7.2, page 16
Connect the Easyfield® sec. 7.3, page 16
Ensure operational readiness, sec. 8.1, page 19
Set up firmware and drivers, sec. 7.4, page 19
Caution
Improper set-up may result in incorrect measurements or equipment
damage
Before you use the device for the first time, the Easyfield® must be
installed and connected by our service personnel or by an OCULUS-
authorized specialist.
7.1 Install the software
If you are working with a PC or laptop, you must install the Easyfield®
software. The Easyfield® software consists of the following programs
which are installed together.
Patient Data Management
Easyfield® program
TNT program
Proceed as described in the
Software Installation
After installing the software, restart the PC or laptop.
7.2 Set-up
The Operating Instructions are found in “Ambient operating
requirements” page 49.
Remove the Easyfield® from the packaging.
Place the Easyfield® on a level surface.
Dispose of the packing material in a proper manner.
7.3 Connect
You must connect the Easyfield® to the power supply, and depending on
the configuration, to the netbook, the laptop or PC. Connection and set-
up will be demonstrated using the example of a netbook connection.
To Next Page
Loading...
Need help?
General
