Patent No. 6,766,028 - OFI Testing Equipment, Inc.
OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ote.com 22
9) 100 RPM
10) 60 RPM
11) 30 RPM
12) 6 RPM
13) 3 RPM
14) 10 second Gel (Wait 10 seconds)
15) 10 minute Gel (Wait 10 minutes)
b. After the completion of the test, results are displayed as follows.
Clicking NEXT allows you to proceed to the next set of readings.
1) “Up Readings” for all the test speeds
2) “Down Readings” for all the test speeds
3) “Avg Readings” for all the test speeds
4) “Gels & Temp”
1. 10 Sec =
2. 10 Min =
3. Temp =
9. In addition to the pre-installed programs (MUD and CEM), the OFITE
Model 900 contains 8 slots for custom programs created with the
ORCADA
®
Software. Refer to page 35 for instructions on creating
custom programs. To access these custom programs:
a. Press the SET UP key twice.
At this point you can press the ENTER key to recall the results of the
last test run.
b. Press the SET UP key again to select a new test to run.
c. Select a test by pressing the numeric key corresponding to the test
you wish to run. The test will start immediately.
d. When the test is complete, the unit will beep.
e. Press the NEXT key to page through the test results.
f. Press the CLEAR/STOP key to return to the main menu.
To Next Page
Loading...
