Why OHAUS Scales does not display accurately?
If your OHAUS scale isn't displaying weight accurately, it might need calibration. Calibrate the scale using the correct calibration weights to ensure accurate readings.
What to do if weight reading does not stabilize on OHAUS BW3US Scales?
If the weight reading on your OHAUS scale is unstable, it could be due to an unstable environment or interference under the pan or sub-platform. Make sure the scale is placed in a stable environment and that the weighing pan and sub-platform are free from any obstructions.
What to do if OHAUS Scales displays “nnnnnn“?
If your OHAUS scale displays “nnnnnn“, it indicates an overload condition, meaning the load on the pan exceeds the scale's capacity. To fix this, reduce the weight on the pan and then re-zero the scale.
Why OHAUS BW3US Scales displays ”- - - - - -”?
If your OHAUS scale displays ”- - - - - -”, it means there's an unstable condition preventing it from establishing zero. To resolve this, place the scale in a stable environment. Additionally, relieve any internal pressure by loosening the leveling feet, clear any obstructions on the vent holes under the rear feet, and remove any weight on the pan that exceeds the power-on zero range.
What does “uuuuuu“ displayed on OHAUS Scales mean?
If your OHAUS scale displays “uuuuuu“, it indicates an underload condition, meaning there is no load on the pan, exceeding the scale's zero. To correct this, install the pan on the sub-platform and then re-zero the scale.
What to do if OHAUS BW3US displays “Error”?
If your OHAUS scale displays “Error”, it indicates a software running error. Try turning the scale off and then on again. If the issue persists, consider replacing the battery.
What does ”E 11“ displayed on OHAUS BW3US Scales mean?
If your OHAUS scale displays “E 11“, it indicates a RAM error. Try turning the scale off and on again to resolve the issue.
Why OHAUS BW3US battery fails to charge fully?
If the battery in your OHAUS scale isn't charging fully, it may be defective or past its useful life. You should have the battery replaced by an authorized Ohaus service dealer.
What does ”E 48“ displayed on OHAUS BW3US Scales mean?
If your OHAUS scale displays “E 48“, it indicates a checkweigh target setting error. To resolve this, review the setup and re-enter the correct Over-Under values.
What does ”E 16“ displayed on OHAUS BW3US mean?
If your OHAUS scale displays “E 16“, it indicates a ROM error. You should recalibrate the scale.
General| Readability | 0.1 g |
|---|---|
| Linearity | ± 0.2 g |
| Repeatability | 0.1 g |
| Calibration | External Calibration |
| Capacity | 3000 g |
| Power Supply | AC Adapter (Included) |
| Units of Measurement | Gram; Kilogram; Ounce; Pound |
| Operating Temperature | 10°C – 40°C |
To Next Page