Why won't my OHAUS Touch Panel turn on with AC power?
There are several reasons why your OHAUS Touch Panel might not be turning on when connected to AC power. It could be a defective power cord, in which case you should check for cuts or abrasions. It may also be a defective power supply, requiring a test. Other potential causes include a defective membrane switch or a defective Main PC Board.
Why is the OHAUS Touch Panel display incorrect or unstable?
An incorrect or unstable display on your OHAUS Touch Panel can stem from several factors. The menu settings might be improperly set, so check the instruction manual. There could be loose or improper wiring on connector J2. Improper calibration may also cause this issue, so recalibrate the device. In some cases, a defective Main PC Board could be the cause.
How to fix communication issues with RS422/485 on OHAUS Touch Panel?
If you're experiencing communication issues using the optional RS422/485 board on your OHAUS Touch Panel, start by checking the menu settings in the Instruction Manual. Also, verify the cable connections according to Figure 3-2. The RS422/485 PC board or the Main PC board might be defective.
Why can't I communicate using RS232 with my OHAUS Touch Panel?
If you're unable to communicate using RS232 with your OHAUS Touch Panel, the menu settings may be improperly set, so check them in the Instruction Manual. Alternatively, the Main PC board could be defective.
Why are the relay functions not working on my OHAUS Touch Panel?
If the relay functions are not working on your OHAUS Touch Panel, it could be due to several reasons: the menu settings might be improperly set, the Relay Board might be defective, the Main PC Board might be defective, or there could be loose or improper wire connections. Refer to Figure 3-2 for proper wiring.
Why does my OHAUS Touch Panel fail to maintain the set time and date?
If your OHAUS Touch Panel fails to maintain the set time and date, the Real Time Clock (RTC) battery may be depleted, so replace the Real Time Clock battery. In some cases, the Main PC Board might be defective.
Outlines essential safety guidelines for the operation and maintenance of the equipment.
Explains how to connect the scale to a power source, including AC and optional battery power.
Instructs on the initial calibration process required before using the scale for accurate measurements.
Covers the different operational modes, including Weighing, Checkweighing, and Library functions.
Details various configuration settings for the scale, including Setup, Readout, Mode, Print, COM, I/O, GMP, Lockout.
Provides detailed instructions for performing scale calibration, including span, linearity, and tests.
Lists common symptoms, their probable causes, and suggested remedies for issues encountered with the unit.
Outlines the setup procedure for enabling Legal for Trade operation and locking metrological parameters.
Details the process of setting the internal LFT switch to lock metrological parameters for legal operation.
General| Units of Measurement | kg, g, lb, oz |
|---|---|
| Tare Range | To capacity by subtraction |
| Calibration | External calibration |
| Power Supply | AC Adapter (Included) |
| Display | LCD |
| Interface | RS232 |
To Next Page
