EN-4 MC2000 Moisture Analyzer Series
3.3 Operation Modes
3.3.1 How to Perform a Test
1. Press button and the instrument starts self-check.
2. Press and buttons to choose the category code of the respective
sample to be measured (refer to section 8, category code list, for details),
press button to enter measurement mode.
3. Fill the sample grain into the empty container.
4. Remove the funnel from container.
5. Remove excess grain with cover.
6. Place the container over the moisture analyzer and press the release
button on the container.
7. Without pressing any key, the analyzer will automatically start the
measurement and the moisture value will be displayed after about 5
seconds.
To Next Page
Loading...
Need help?
General
