OHAUS STARTER 300 - Page 6

4
Controls
Button
Press & release
Press & hold
for 3 seconds
- Start or endpoint
measurement
- Confirm setting, store entered
value
- Turn auto endpoint on / off
,
- Start calibration
- Review the latest calibration
data
- Meter on
- Back to measurement screen
- Meter off
- Store current reading to
memory
- Increase value during setting
- Scroll up through the memory
- Recall stored data
- Switch between pH and mV
measuring modes
- Decrease value during setting
- Scroll down through the
memory
- Enter setup mode
- Start self-diagnosis