The electrode clip is an electrode holder that can be placed next to the display on either side of
the housing.
1) Attach the clip by inserting the tabs into the recess.
2) Slide the clip forward to lock in position. Slide the shaft of the sensor into the clip from above.
2.4 Installing the IP54 cover
Use the small plastic tool as shown:
2.5 Integrated stand for table top use
One unique design feature of the STARTER 300 meter is the integrated stand as shown, which
can be pushed out to use the meter at the table. To close the stand, please take the mid-edge of
the stand.
To Next Page
