Why can't I zero my OHAUS Accessories scale?
This may happen if the load on the scale exceeds allowable limits or is not stable. Remove any load from the scale and wait for it to stabilize. If the issue persists, service is required, as it may indicate load cell damage.
What to do if my OHAUS Accessories shows Error 8.3?
If the OHAUS Accessories scale displays Error 8.3, it indicates that the weight reading exceeds the overload limit. To resolve this, reduce the load on the scale.
What to do if my OHAUS Accessories scale shows Error 8.6?
If the OHAUS Accessories scale displays Error 8.6, it means the weight exceeds six digits, causing a display overflow. To fix this, reduce the load on the scale.
What to do if my OHAUS Accessories shows Error 8.1?
If the OHAUS Accessories scale displays Error 8.1, it indicates that the weight reading exceeds the Power On Zero limit. Remove the load from the scale and then recalibrate the scale to resolve this issue.
What to do if my OHAUS Accessories shows Error 8.2?
If the OHAUS Accessories scale displays Error 8.2, it means the weight reading is below the Power On Zero limit. Add load to the scale and then recalibrate the scale.
What to do if my OHAUS Accessories scale shows Error 8.4?
Error 8.4 indicates the weight reading is below the Underload limit. Add load to the scale and then recalibrate.
Why does my OHAUS Accessories display Error 8.6?
Error 8.6 appears when the weight exceeds six digits, causing a display overflow. Reduce the load on the scale.
What to do if my OHAUS Accessories scale shows Error 8.1?
Error 8.1 means the weight reading exceeds the Power On Zero limit. Remove the load from the scale and then recalibrate it.
What does it mean when the battery symbol is flashing on my OHAUS Accessories?
If the battery symbol is flashing on your OHAUS Accessories (T52P), it indicates that the batteries are discharged and need to be replaced.
How to display weight in the desired weighing unit on my OHAUS Accessories?
If your OHAUS Accessories cannot display weight in the desired weighing unit, the unit may not be set to On in the Units Menu. Enable the unit in the Units Menu.
General| Display | LCD |
|---|---|
| Protection | IP54 |
| Legal for Trade | Yes |
| Calibration | External Calibration |
| Power Supply | AC Adapter |
| Dimensions | 300 x 300 x 120 mm |
| Communication | RS232 |
| Operating Temperature | 0 to 40 °C |
| Relative Humidity | 10% to 85% non-condensing |
To Next Page
