Need help?Do you have a question about the Ohmeda 3000 and is the answer not in the manual?
Outlines the procedures and policies for servicing the equipment.
Specifies required skills and knowledge for service personnel.
Highlights critical safety warnings for operation and maintenance.
Provides essential cautions regarding safe servicing and handling.
Details the functions and components of the Infant Warmer's power supply.
Explains the circuitry, microcontroller, and interfaces of the control board.
Describes the display board's interface, controls, and LED display driver.
Lists power requirements and electrical specifications for the units.
Details the controller's electronic capabilities and operational modes.
Describes the various audio and visual alarms used by the system.
Specifies operating and storage temperature and humidity ranges.
Provides physical dimensions and weight specifications for the unit.
Lists optional accessories available for the Infant Warmer System.
Instructions for unpacking and initial setup of the unit after shipment.
Step-by-step procedure for verifying unit functionality before use.
Steps for accessing the control unit and checking power supply voltages.
Procedures for adjusting display brightness and alarm volume.
Steps for calibrating the ADC and verifying temperature readings.
Procedures for line voltage compensation and triac safety circuit testing.
Procedure for performing a complete unit test loop.
Instructions for performing power cord inspection and safety checks.
Procedures for ground resistance and leakage current tests.
Procedures for disassembling and repairing the heater module.
Steps for removing and repairing the control module assembly.
Procedures for replacing the control and power supply boards.
Steps for disassembling and assembling the display module.
Procedures for battery replacement and bed platform repairs.
Steps for hydraulic system and caster replacement.
Steps for replacing the unit's casters.
Procedures for strainer, check valve, and regulator service.
Lists error codes, descriptions, and possible causes for system failures.
Illustrated parts and part numbers for the warmer frame assembly.
Illustrated parts and part numbers for controller assemblies.
Illustrated components and part numbers for power supply, control, and display boards.
Illustrated parts and part numbers for harnesses and heater housing.
Illustrated parts and part numbers for the bed and oxygen yoke assemblies.
General| Brand | Ohmeda |
|---|---|
| Model | 3000 |
| Category | Food Warmer |
| Language | English |
To Next Page
