Ojmar OCS SMART - OCS Lock LED Indicator Meanings; Replacing OCS Lock Batteries

OCS SMART _ USER MANUAL _ VERSION 1.00 OJMAR 36
On start-up (removing and inserting a battery) and within 3 seconds press:
‘‘START’’ + 987654321 + 73 + LOCK
2.5 DESCRIPTION OF LED FLASHES
The OCS lock has an LED that indicates both the operations it is carrying out and any
errors that may occur.
These messages are listed in the following table.
GREEN
LED
RED LED
AMBER
LED
DURATION DESCRIPTION
3 flashes
Short
(100ms=1/10s)
Turn on sequence
flashing. This flashing
occurs when the front part
of the lock is connected to
the locking module.
1 flash
Long (1s.)
Correct opening or
locking.
1 flash
Very Short
(50ms=1/20s)
Pressing of a key or
automatic opening.
1
flash
Long (1s.)
Definitive low battery
detection. The OCS will not
lock again until the
batteries have been
changed. This flashing will
occur at the start of the
cycle (on pressing ‘‘start’’
and on waking the lock
up).
2 flashes
Medium
(250ms=1/4s)
The entered code is
incorrect.
4 flashes
Medium
(250ms=1/4s)
Mechanical error. Contact
Ojmar to resolve the
problem.
• NOTE: During communication between the app and the lock, the LED flashes
blue.
2.6 REPLACING THE LOCK BATTERY
The lock is able to detect a low battery charge level. After detecting a low battery it
will allow opening but never closing, preventing the locker from getting blocked and
having to force it to open it.
Follow the steps listed below to replace the batteries: